BASEMENT FLOOR COATING PITTSBURGH — MOISTURE HANDLED FIRST.

Maybe. “Damp” covers everything from high humidity to standing water, and the moisture reading tells us which you have. Humidity is workable; active water intrusion needs fixing first.

We do not quote the coating. We tell you what is causing it and what typically fixes it — grading, gutter extensions, drain tile, a sump — and re-test once sorted. No charge either way.

Both work below grade, and this is the one room where epoxy is genuinely defensible: no UV, so it will not yellow. Epoxy makes a good high-build base and moisture-mitigating primer. We top it with polyaspartic anyway — it cures in about an hour instead of overnight, and it is far more abrasion-resistant under gym equipment or a workbench.

It is a concrete slab, so yes, similar to tile — but no colder than the bare concrete was. Area rugs fix it, as does in-floor heat in a full renovation.

$5–$12 per square foot installed. A 900 sq ft basement typically runs $4,500 to $9,000, plus vapour-mitigating primer if the reading calls for it. Older pre-1960 slabs sit toward the top.

Briefly and mildly. Low-VOC polyaspartic, containment and ventilation. Most households stay in the house.

We coat up to them and detail the edges cleanly. Drains stay functional — we do not cover them.

Not over — through. It gets ground off first. That adds cost, and it shows on the quote.

A coating is not a radon mitigation system and we will not sell it as one — if you have elevated radon, hire a licensed mitigator. What it does do is remove the porous, dust-shedding surface mould colonises, and give you a floor that dries fast instead of holding damp.